Construction of a nearly exact KIM-1 replica keyboard.
Original version: Design, images and original text in German by Ralf (ralf02, forum64.de), from the KIM-1 Aufbau anleitung, and KIM-1 Keypad by user hackup, October 30, 2022 on thingiverse
For the keyboard construction you need the following parts:
- 1 3D printed keyboard frame, STL from thingiverse
- 2 keypads with 16 keys each as shown (actually, you just need 1 1/2)
- 1 keypad PCB, see the gerber file
- 1 SPDT slide switch, 2.54mm pitch
- 1 female pinheader connector, 15 pins, preferably low profile
- 1 male pinheader, 15 pins to match the female one
- 6 self tapping screws, 2x6mm
- labels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RS
- double sided adhesive tape to glue the clips to the motherboard
The keyboard PCB has to be gold plated (ENIG). With tin-plated PCBs the contact from the keys is not reliable.
Downloads made available by Ralf:
- Circuit diagram of keyboard PCB
- Gerber files of PCB
- STL files of keyboard case, original on Thingiverse
- Label files of keycaps for a Brother printer
- KIM-1 Aufbauanleitung, section on keyboard construction
First dismantle the two keyboards and cut the two rubber contact mats as seen in the next picture. Keys 0-0 and A-D have the right lettering, make the other with a letter printer white on black.
Place the keycaps in the 3D printed case:
Now solder the slide switch and the pinheader on the PCB. Cut the rubber mat on the location of the slide swithc. Put the mat in the 3d printed case and fix with 6 screws:
Next place the four M3 screws in the holes in the PCB and the parts in the case. Now place the PCB on the 1 pin pinheader and fix the four screws with washers from the bottom.
The two reds are only for decoration, to make it look like as on the KIM-1.
Next photos credit to Bigby (of forum64.de):
This page is about the operation and use of the Rockwell Single-Chip RSC-FORTH system as implemented in the Rockwell R65...
Rockwell made many 6502 variants. Some were 'SOCs', complete computers in an IC. and Rockwell was strong in Forth, e.g....
I have two R6501 IC's. One came with the Glitchworks GW-R65X1QSBC-1 kit, a R6501Q. The other from ebay, a R6501AQ (A for...
I have recently acquired a R65F11 IC. This IC is part of the RSC (Rockwell Single Computer) Forth system. Rockwell Sin...