A KIM-1 clone build by Bob Applegate of Corsham Technologies.
The idea was replace the 6530’s with 6532 and by careful memory decoding have the I/O, timer and RAM of the 6532’s appear at the same locations as the 6530-002 and -003. ROM is added with an EPROM.
Not an exact copy in dimensions , and the ROM has been changed/enhanced/improved with a xKIM Monitor by Bob Applegate (hex upload e.g.), though the original KIM-1 ROM should work also.
The result is a high quality build, and an exact KIM-1. With many extra’s
Available assembled and tested or as a kit. I have bought the Rev 2 PCB with essential parts from Corsham to build it!
And also bought the assembled Rev 5 with expansion connector, motherboard, Proto board, KIM Clone I/O and SD/RTC Shield.
This is a dream of a 6502 development system! The SD shield has a simple interface in the xKIM monitor to load and save files on the SD, which is a FAT formatted card, Fast enough of course and easy to exchange fiiles on a PC with a cross assembler.
Besides the KIM Clone I have a KIM-1 60K RAM/ROM board and a KIM I/O board, connected tot he MOS Technology KIM or my original KIM-1.
What you find here:
- Adding I/O to the KIM-1
- KIM Clone information
- Corsham KIM Clone peripherals
- Corsham SD card system
- KIM Clone software
- Using KIM Clone I/O
Photos of my Corsham Technologies cards:
KIM-1 RAM/ROM and I/O board connected to a KIM-1
See also:
This page is about the operation and use of the Rockwell Single-Chip RSC-FORTH system as implemented in the Rockwell R65...
Rockwell made many 6502 variants. Some were 'SOCs', complete computers in an IC. and Rockwell was strong in Forth, e.g....
I have two R6501 IC's. One came with the Glitchworks GW-R65X1QSBC-1 kit, a R6501Q. The other from ebay, a R6501AQ (A for...
I have recently acquired a R65F11 IC. This IC is part of the RSC (Rockwell Single Computer) Forth system. Rockwell Sin...